Transient liquid phase sintering of high-purity mullite for high-temperature structural ceramics

High-purity mullite ceramics, promising engineering ceramics for high-temperature applications, were fabricated using transient liquid phase sintering to improve their high-temperature mechanical properties. Small amounts of ultrafine alumina or silica powders were uniformly mixed with the mullite precursor depending on the silica-alumina ratio of the resulting ceramics to allow for the formation of a transient liquid phase during sintering, thus, enhancing densification at the early stage of sintering and mullite formation by the reaction between additional alumina and the residual glassy phase (mullitization) at the final stage of sintering. The addition of alumina powder to the silica-rich mullite precursor resulted in a reaction between the glassy silica and alumina phases during sintering, thereby forming a mullite phase without inhibiting densification. The addition of fine silica powder to the mullite single-phase precursor led to densification with an abnormal grain growth of mullite, whereas some of the added silica remained as a glassy phase after sintering. The resulting mullite ceramics prepared using different powder compositions showed different sintering behaviors, depending on the amount of alumina added. Upon selecting an optimum process and the amount of alumina to be added, the pure mullite ceramics obtained via transient liquid phase sintering exhibited high density (approximately 99%) and excellent high-temperature flexural strength (approximately 320 MPa) at 1500 °C in air. These results clearly demonstrate that pure mullite ceramics fabricated via transient liquid phase sintering with compositions close to those of stoichiometric mullite could be a promising process for the fabrication of high-temperature structural ceramics used in an ambient atmosphere. The transient liquid phase sintering process proposed in this study could be a powerful processing tool that allows for the preparation of superior high-temperature structural ceramics used in the ambient processing atmosphere.     

Direct Injection of CRISPR/Cas9-Related mRNA into Cytoplasm of Parthenogenetically Activated Porcine Oocytes Causes Frequent Mosaicism for Indel Mutations

Some reports demonstrated successful genome editing in pigs by one-step zygote microinjection of mRNA of CRISPR/Cas9-related components. Given the relatively long gestation periods and the high cost of housing, the establishment of a single blastocyst-based assay for rapid optimization of the above system is required. As a proof-of-concept, we attempted to disrupt a gene (GGTA1) encoding the α-1,3-galactosyltransferase that synthesizes the α-Gal epitope using parthenogenetically activated porcine oocytes. The lack of α-Gal epitope expression can be monitored by staining with fluorescently labeled isolectin BS-I-B₄ (IB4), which binds specifically to the α-Gal epitope. When oocytes were injected with guide RNA specific to GGTA1 together with enhanced green fluorescent protein (EGFP) and human Cas9 mRNAs, 65% (24/37) of the developing blastocysts exhibited green fluorescence, although almost all (96%, 23/24) showed a mosaic fluorescent pattern. Staining with IB4 revealed that the green fluorescent area often had a reduced binding activity to IB4. Of the 16 samples tested, six (five fluorescent and one non-fluorescent blastocysts) had indel mutations, suggesting a correlation between EGFP expression and mutation induction. Furthermore, it is suggested that zygote microinjection of mRNAs might lead to the production of piglets with cells harboring various mutation types.     

Liquid Marble Patchwork on Super-Repellent Surface

Liquid marble (LM) is a droplet that is wrapped by hydrophobic solid particles, which behave as a non-wetting soft solid. Based on these properties, LM can be applied in fluidics and soft device applications. A wide variety of functional particles have been synthesized to form functional LMs. However, the formation of multifunctional LMs by integrating several types of functional particles is challenging. Here, a general strategy for the flexible patterning of functional particles on droplet surfaces in a patchwork-like design is reported. It is shown that LMs can switch their macroscopic behavior between a stable and active state on super-repellent surfaces in situ by jamming/unjamming the surface particles. Active LMs hydrostatically coalesce to form a self-sorted particle pattern on the droplet surface. With the support of LM handling robotics, on-demand cyclic activation–manipulation–coalescence–stabilization protocols by LMs with different sizes and particle types result in the reliable design of multi-faced LMs. Based on this concept, a single bi-functional LM is designed from two mono-functional LMs as an advanced droplet carrier.     

A low-resistance self-aligned T-shaped gate for high-performancesub-0.1-μm CMOS

This paper describes the high performance of T-shaped-gate CMOS devices with effective channel lengths in the sub-0.1-μm region. These devices were fabricated by using selective W growth, which allows low-resistance gates smaller than 0.1 μm to be made without requiring fine lithography alignment. We used counter-doping to scale down the threshold voltage while still maintaining acceptable short-channel effects. This approach allowed us to make ring oscillators with a gate-delay time as short as 21 ps at 2 V with a gate length of 0.15 μm. Furthermore, we experimentally show that the high circuit speed of a sub-0.1-μm gate length CMOS device is mainly due to the PMOS device performance, especially in terms of its drivability     

A Model of the Relationship Between Psychosocial Variables and Diurnal Cortisol Rhythm Under Chronic Stress by Using Structural Equations

By using structural equations, we investigated the effect of chronic stress on salivary cortisol rhythm and proposed a causal model of chronic stress by using psychosocial and physiological data. First, 111 healthy workers (48 males, 63 females) completed questionnaires on chronic stress and lifestyle habits. Then, they provided saliva samples and answered questionnaires that were prepared to assess their psychological states 5 times (on waking up and at 10:00, 11:40, 14:00, and 16:00) on workdays. Structural equation modeling (SEM) revealed that chronic stress and longer commuting time resulted in sleep irregularities and this disrupted the cortisol circadian rhythm. This suggests that chronic stress disrupts the cortisol circadian rhythm even in healthy individuals, and sleep regularity mediates the effect of chronic stress on the cortisol rhythm.

     

Automated camerawork for capturing desktop presentations

A novel automated camera control method for capturing desktop presentations is introduced. Typical features and the camerawork of shots that appear frequently in TV programs are discussed. To realise those features in this automated video capturing system, the purpose of camerawork is classified from two points of view: target and aspect-of-target. Then, the correspondence between the classification and typical shots and camerawork is considered. A virtual-frame control algorithm based on this idea is proposed, and its implementation in a video production system. Results are shown that verify this method through two kinds of experiments, virtual video capturing using CG animations and real video capturing of real presentations.     

Infrequent mutation of the H-cadherin gene on chromosome 16q24 in human breast cancers

To investigate the molecular basis of altered expression of the H-cadherin gene, we used polymerase chain reaction-single strand conformation polymorphism and DNA sequencing to examine the H-cadherin gene in 48 primary breast cancers in which loss of the long arm of chromosome 16 had been detected. We identified no mutations other than somatic 5-bp deletion within the coding region in a single tumor. The very low frequency of mutation found in these experiments suggests that H-cadherin is usually not a primary target for carcinogenesis in human breast cancers, and that reduction of its expression is likely to be a consequence of some other genetic event(s).     

Assessing Environmental Risks: Lessons From Superfund

This essay analyzes the use of risk assessment in Superfund, the controversial American hazardous waste cleanup programme. We argue that risk assessment has been used in three ways in discussing policy options in this programme: as a metric for assessing performance; as a means for resolving conflicts; and as a tool for comparing different environmental initiatives. Use of risk reduction as an analytical tool in European efforts to clean up hazardous waste sites is discussed. We conclude that while risk assessment has potential utility for each of these applications, there are also accompanying technical and political difficulties.     

On A Maximum Likelihood Method for Clustering

Behaviormetrika - In this paper, we propose a new clustering method based on the concept of maximum likelihood (ML) estimation. In general, the problem of local minima arises when we try to use the...